|
A
feasible and economically viable unit for manufacture of Crown
Corks should comprise (for
average daily production of crowns):
|
Machine
Specifications
|
125,000
(3 Cavity Die)
|
250,000
(6 Cavity Die)
|
|
Special-purpose
Titan Type Auto Strip Feeder, Double Ram Action,
Crown Cork Punching Press, with Multi-Cavity
Die
|
1
|
1
|
|
Special-purpose
Double Ram Action, Crown Crock Punching Machine
with Single Cavity Crown Blanking Die
|
1
|
1
|
|
Shearing
Machine 40
|
1
|
1
|
|
PVC
Spinning or Moulding Machine will be as per production specification
Raw
Material
Crown
Corks are made from 31 SWG i.e. .250 mm thick Tin Sheet or
Tin Free Sheet (TFS) IN T 4 temper. The multiple dies for
the same are made with a tolerance of ± 2%.
PVC
Lining
Crown
Corks are lined with PVC Lining. This serves as a liner cushion.
PVC Which comes in liquid or dry blend form,
has to be applied inside each Crown Cork, With a dispensing/application
machine.
After application, this material cured at
a high temperature of over 250 degrees C. For PVC application,
We have developed Automatic dispensing machines, Which besides
Spinning or moulding, as the case may be, has an integrated
& synchronised Stoving tunnel oven.
The machines are offered in two different
production capacities:
- 125,000 Crowns per eight hour shift
- 250,000 Crowns per eight hour shift
In Keeping with the our policy of continuos
development and improvement, the dimensions and specifications
may be changed without prior notice or obligation. Where-ever
given, dimensions are approximate.
Electricals
As
in the case of all other machines supplied by us, Crown Cork
manufacturing machines too are supplied complete with suitable
electric motors, starters and air blowing units and compressor.
Unless otherwise ordered, the machines are fitted with electricals
rated for 440 volts, 3 phase, 50 cycles supply.
|
|
